EMFields PF5 Low Frequency Meter / Acousticom 2 RF Meter/ Alphalab Powerline Mtr

Description

EMFields PF5:
This compact meter measures electric and magnetic EMFs from house wiring, including those from appliances at home at at work. The PF5, unlike most EMF meters on the market,
also
measures frequencies in the range from 20 Hz to well over 50 kHz. This enables the PF5 to measure the higher frequency electric and magnetic fields emitted by induction cooking hobs, solar-panel inverters, ‘energy-saving’ compact fluorescent (CFL) lamps and some LED lights.
The PF5 is an easy to use, pocket sized, accurate, power-frequencies meter which is ideal for carrying around. It measures both electric and magnetic fields. This model uses milliGauss (mG) units.
PF5 Technical Specifications
A line of coloured LEDS shows the level
Electric fields range: 5 – 200 V/m
Frequency range: 15 – 2000 Hz ±3% typical accuracy)
Magnetic fields range: 0.02 – 2.0 µT
» also available scaled 0.2 – 20 mG
Resolution: 8 LEDs plus 7 middle points
Accuracy: 50 to 2000 Hz ±10%
Accuracy: 20 to 50000 Hz ±3 dB
with a useable response from 15 Hz – 70 kHz
Battery: PP3 9V Alkaline or Rechargeable
Current: 16-23 mA
Battery life: 25 hours (normal alkaline)
Low battery (6.7V) shown by red V/m LED
Size (mm): 110 x 63 x 21 (LxWxD)
Weight:140g incl.battery; 175g with pouch
EMFields Acousticom 2 RF Meter
The Acousticom 2 presents RF measurements as an audio signal, with LEDs and an alarm at high levels of RF (you can also switch the sound off if you prefer to be less obvious when taking readings). With simple controls, easy to read results, but still using the same advanced microwave detector as the Acoustimeter AM-10, this instrument is perfect for those on a budget. It is smaller and lighter than the Acoustimeter, and comes in its own carry pouch.
When first turned on the Acousticom 2 is silent. The sound may be turned on and off by pressing the button. The Acousticom 2 also has an “alarm” sounder which emits a pulsing warning at higher exposure levels. If the alarm is not required, then it is easy to disable it each time when you turn the Acousticom 2 on. The demodulated sounds allow you to determine, with a small amount of practice, what type of device is creating the pulsing microwave levels that are present. These features make the instrument the most useful and practical one available – even for people with severe electrosensitivity.
Buy this meter if you want a simple, compact and precise meter to measure wireless communications in the radio frequency spectrum.
Acousticom 2 Technical Data:
A line of coloured LEDS displaying Peak exposure levels in V/m
Measurement range: 200 – 8 000 MHz ±6 dB (typical accuracy)
Sensitivity (Peak Display): 0.01 – 6.00 volts per metre (V/m)
0.01 / 0.02 / 0.05 / 0.1 / 0.3 / 1.0 / 3.0 / 6.0 V/m;
(equivalent to 0.5 to 100,000 peak µW/m
2
)
Some intermediate points when two LEDs are both lit are also defined: 0.2 / 0.6 / 2.0 / 4.5 V/m
The speaker may be switched on and off
An alarm sounder at higher exposure levels (may be disabled)
Power source: 1x PP3/MN1604 9 volt Alkaline or Rechargeable
Battery life: Up to 10 hours continuous with normal alkaline battery
»
Low battery indicator light (the green ‘on’ light turns red)
Size (mm): 110 x 63 x 21 (LxWxD); Weight: 140g incl. battery
Includes soft shell zipper case
Alphalab Powerline Meter:
The Alphalab Power Line Meter is an essential tool to measure and reduce “dirty electricity” in your home, caused by smart meters and other electronic devices. The Powerline Meter plugs into a wall outlet and requires no battery. It immediately displays total line noise in millivolts (range 1999 mV, resolution 1 mV) in the frequency range 10 KHz – 10 MHz. A speaker plays the sound of the Electro-Magnetic Interference (EMI), amplitude demodulated, in order to identify the source. Equivalent of a "stetzer meter" but has a wider frequency range, and includes sound feature to id source of DE pollution.
Alphalab Powerline Meter Technical Data:
Operating Voltage: 85-250 VAC 50/60 Hz.
Voltage Reading: 85-250 VAC; Accuracy +/- 1 VAC
Line Noise Range: 1-1999 mVAC (differential)
Line Noise Accuracy:  +/- 5% @ 1MHZ; +5% to -50% @ 10 KHz TO 10MHz.
Size: 5.2 x 3.6 x 1.6 inches; 132 x 91 x 41 mm
Weight: 8 oz.
Power Cable: Detachable 2-wire cord (North America)
Advantages of purchasing from Stop Smart Meters:
1) We are a EMFields and Alphalab authorized reseller, so any warranty issues are easy to handle.
2) All EMFields EMF Meters utilize precautionary guidelines in setting up colored LED power density levels.
3) All sales support outreach and awareness raising work of Stop Smart Meters!
4) Fast, expedited USPS shipping
5) Comes with full personalized phone or email support, outreach materials, and stickers